DV-20X2H Dynavector High output MC cartridge
Bought as ex demo from a dealer 4 years ago
Not a lot of hours, not really been used until recently as I’ve been ill.
Boxed with all bits, (only two bolts) and brush
Reason for selling is I’ve gone for a LOMC
Info here
https://www.dynavector.com/products/cart/e_20x2.html
Type High output moving coil cartridge with flux damper and softened magnetism
Output Voltage 2.8mV (at 1KHz, 5cm/sec.)
Channel Separation 25 dB (at 1KHz)
Channel balance 1.0 dB (at 1KHz)
Frequency response 20 - 20,000Hz (± 1dB)
Compliance 12 mm/N
Tracking force 1.8 - 2.2 g
Impedance 150 ohms
Recommended load impedance > 1,000 ohms
Cantilever 6mm length, hard aluminium pipe
Stylus tip Micro Ridge Nude diamond
Weight 9.2 g
£180 posted , £170 or very near offers, collected from near Kidderminster
(Will try to get close ups, but don't think my camera kit is good enough!)
Please PM
Bought as ex demo from a dealer 4 years ago
Not a lot of hours, not really been used until recently as I’ve been ill.
Boxed with all bits, (only two bolts) and brush
Reason for selling is I’ve gone for a LOMC
Info here
https://www.dynavector.com/products/cart/e_20x2.html
Type High output moving coil cartridge with flux damper and softened magnetism
Output Voltage 2.8mV (at 1KHz, 5cm/sec.)
Channel Separation 25 dB (at 1KHz)
Channel balance 1.0 dB (at 1KHz)
Frequency response 20 - 20,000Hz (± 1dB)
Compliance 12 mm/N
Tracking force 1.8 - 2.2 g
Impedance 150 ohms
Recommended load impedance > 1,000 ohms
Cantilever 6mm length, hard aluminium pipe
Stylus tip Micro Ridge Nude diamond
Weight 9.2 g
£180 posted , £170 or very near offers, collected from near Kidderminster
(Will try to get close ups, but don't think my camera kit is good enough!)
Please PM
Last edited by a moderator: