Running a pre and power amp combo without speakers. Is this Ok?

[wizons]

I wish to resurrect a Quad 99pre that hasn't been used for about 5 years, but would like to check all is OK before it's connected to my main system. Assuming the pre needs to be connected to a power amp in order to make a circuit whilst being tested, is it OK to do this for a few hours without speakers connected to the power amp?

Thanks

 

[Joelsim]

I doubt you'll hear much.

 

[hearingisbelieving]

If its solid state it will be fine but not sure what exactly you will be able to test except that it switches on and doesnt blow up after a few minutes. suggest you nip down your local crackconverters and get some cheapo £10 speakers to hookup for testing...

 

[awkwardbydesign]

I have a couple of 8 ohm/ 10 watt resistors for this, Mind you, I'm usually checking valve amps.

 

[Tenson]

Grab a speaker out an old bit of rubbish kit; TV, radio, dumped midi-system etc..