t-nuts @ 15mm

[RobsterD]

Looking for small m5 t-nuts at 15mm width any sources ...eBay just seem to have the 18mm stuff which ain't any good for mounting my PHY drivers

 

[Radioham]

Hi

Can you explain further m5 t-nuts at 15mm width ? I assume M5 is the bolt size and 15mm the diameter of the nut ? I will check later this morning as I have 8 spare which came with some NOS KEF B200's this week.

Alan

 

[Radioham]

Hi,

I checked the spares this morning and they are closer to 18mm diameter than 15mm. I assume they must fit in a rebated hole, as normally the diameter of the flange is not important, since it normally goes against the back of the front baffle.

Alan

 

[RobsterD]

Thanks for looking Alan but it is the flange at 15mm,bought a load from somewhere ages ago and have two left ,can't remember from where I got them !

 

[paulf-2007]

Is it possible to reduce the flange size to 15mm diameter rob ? 5mm bolt nut and t nut locked together in a cordless drill or pillar drill and a file or send to me and I could turn them on the lathe

 

[RobsterD]

Cheers Paul,will continue my search...

They are out there but minimum orders of £20 and packs of 100

https://www.comdir.co.uk/Products.aspx/vqgllkny18/