More downsizing.
I've got a Firebottle phono pre-amp up for sale with a Sean Jacobs (Custom Hi-fi) DC2 power supply.
There's a thread on AOS (https://theartofsound.net/forum/showthread.php?26892-FIREBOTTLE-Phono-Preamp) about the phono amp.
The DC2 was built to the specs for the phono amp:
Regulated High Tension supply.
Surge protected dc heaters.
Passive RIAA equalisation.
Frequency response: ------------------------------ wide ---------------------------------
Supply voltage: 12 – 15 volts DC, 1.7A
DC input: 2.5mm DC socket, centre pin positive.
Input impedance: 47 Kohm, 80 pF.
Gain: 44 dB @ 1KHz.
Output impedance: 600 ohms.
Not been used for a while but it was fired up today and all works fine - sounds good too.
I no longer use vinyl which is why this setup is for sale.
Back in 2013 the DC2 was £230 and I think the Firebottle was £230 as well.
I'm asking for £250 delivered.
I've got a Firebottle phono pre-amp up for sale with a Sean Jacobs (Custom Hi-fi) DC2 power supply.
There's a thread on AOS (https://theartofsound.net/forum/showthread.php?26892-FIREBOTTLE-Phono-Preamp) about the phono amp.
The DC2 was built to the specs for the phono amp:
Regulated High Tension supply.
Surge protected dc heaters.
Passive RIAA equalisation.
Frequency response: ------------------------------ wide ---------------------------------
Supply voltage: 12 – 15 volts DC, 1.7A
DC input: 2.5mm DC socket, centre pin positive.
Input impedance: 47 Kohm, 80 pF.
Gain: 44 dB @ 1KHz.
Output impedance: 600 ohms.
Not been used for a while but it was fired up today and all works fine - sounds good too.
I no longer use vinyl which is why this setup is for sale.
Back in 2013 the DC2 was £230 and I think the Firebottle was £230 as well.
I'm asking for £250 delivered.