PCB for DIYers

[Colin Wonfor]

M50/s Pre amp Line in and a DAC .
Input 1 DAC. 3 Line,
Output 2 Non Balance Pre. 1 Balance Pre, SECA HP
Again supplied with cct and BOM.

Cost £100 + P&P

This project for DIYer is based on the Q20 circuit but it can give you power level greater than 50W.
The top PCB is the Power Amp you get 2 off these the bottom PCB is the split psu board for the power amps, the 2 circuit boards are toys for the kid and are a FM TX low power device. Again it come with circuit diagrams and a BOM. Cost is £100 +P&P

I am selling a few blank circuit board for product that will not be available ready made.
This first one is based on the TQ Claymore but it has no Remote control. And it had a Mini DAC and MC/MM and a better pcb arrangement for ease of build each one comes with cct diagrams and a BOM.
This PTH PCB is for the DIY folk and has SMD and leaded devices. All yous for £80 + P&P.

 

[MF 1000]

Think you might need to register as a dealer Colin 

 

[Colin Wonfor]

No I am retired selling of odd bits. Once the small stock has gone that will be it. 

Also will be selling test kit etc.

Now I am 66 and not in good health, and the old bones hurt to much etc.

I just want to enjoy what is left relaxing to Music, Good film, a book and the few days out I get a month on the Thames river boats.